- Electromagnetic heating panels
- Electromagnetic induction heat
- Electromagnetic heating Guiji
- Electromagnetic induction furn
- Electromagnetic induction alum
- Induction Melting Furnace
- Electromagnetic induction melt
- Electromagnetic heating energy
Address:Dongguan city Tangxia first Industrial Zone No. 8
Product name: the new 5 kw electromagnetic heating panel 5 kw
A, electromagnetic heating panel technical parameters
1: appearance; 8 kg
2: working voltage: 220 v
(adjustable) : 3: power 3500 w to 5000 w
4: the load inductance: 65 + 5 uh
5: conversion efficiency > 90%
6: working frequency: 20 to 25 KHZ
7: working temperature: - 10 degrees to + 50 degrees
8: works: continuous heating
9: the wave impact protection - + 1500 v
10: clutter interference: 4000 v
11: induction coil to the installation of heating element from 15 to 18 mm (the thickness of heat preservation cotton after compaction)
And more than 12: coil around the same heating element, the coil of the distance between each other is greater than 6 cm.
Second, the electromagnetic heating panel wiring instructions
1, three lights, for the "power", "work" and "failure" lamp. "Power supply", "work" in normal working conditions in the light. "Fault" lights went out. Failure occurs when the electricity road "fault" light in bright.
2, power 220 v in the "220 v power input" posts, all wire zero access can casually.
3, coil on the "OUT1OUT2" two terminal, tighten the screws.
4, the electromagnetic heating panel factory set for the power supply can work, the "controlled" switch socket mouth there is a short route (black) to the outlet short circuit. Also can use handle gently on the next "switch control", the only outlet short route (black), will be one of the two core online line one end into the socket switch control, the other end of the two plugs from the thermostat two normally open contacts, linked to commissioning.